Home Server Rooms? 464
Tuzanor
writes "I've got a buddy moving into a brand new house. Being
geeks, we've decided to wire the house with a large home network.
While this story
took care of wiring the house, we need to figure out how to create a
well set up server room. We'll be having both towers and rack mounted
computers as well as various switches, UPSes, etc. Also, we figure
this room will get warm, even in winter. How may we cool it while
still keeping the rest of the house toasty warm on a cold
Canadian night (without opening a window)"
Come on... (Score:4, Insightful)
Just set up the ventilation system to suck warm air from the top of the server room, and pipe it to the colder rooms in the house.
For air return, install intakes near the bottom of some of the colder rooms.
It would cost like $50 at a home improvement store to get enough flexible ducting and registers.
Go to a surplus site like www.mpja.com and get some AC powered fans with a good CFM output.
Re:ceiling vent (Score:2, Insightful)
Heat, Noise Issues (Score:2, Insightful)
Personally, I've got my boxen sitting within inches of the furnace and I've had them there for months without a problem. I live in Seattle, about 125 miles from the Canadian border so the climate is somewhat similar. Unless your buddy is looking at putting in loads of servers and other equipment I can't imagine that you'd have a problem. If you really want to 'do it right' you can usually get most manufacturers to give you the heat output rates for their equipment in BTUs per hour. Add all the rates together then you'll have an idea of how bad things are likely to get. I would imagine you'd have more problems with too much heat then not enough; it might not be a bad idea to check the room where the rack is going to go and verify that it has adequate ventilation to carry the heat load. Stick a wall-mounted thermometer in and see how it goes over time.
One thing that you should really think about with rack equipment is the noise level. Manufacturers of rack-mounted equipment just love to shove lots and lots of fans in the backsides of their boxes; this tends to make a great deal of unwanted noise. Unless the plan is to have all this stuff in a separate room where no one is going to be in you might want to consider spending the extra money and get a glass or plastic enclosed rack. It costs more but hey, it definitely has the cool factor covered.
Re:electricity (Score:4, Insightful)
Use The Heater, and a Few Other (Odd) Ideas (Score:4, Insightful)
Another suggestion is that when I lived in Salt Lake City our house had water heating. What if you ran pipes behind the computers with fins on the pipes (like a heatsink) then that water could go into the hot water heater. Once again, saving you some money.
Where is the room located physically? Don't forget that an underground external room (as opposed to a room in the middle of the house) will be cooler.
Being true geeks, you're probably not opposed to spending some moolah on this. What about doing something like this [freeserve.co.uk] guy did? If you buried a few large tanks deep the ground deep so it's below the frost line, you'd get cold water for free. Then just hook all you're PCs into water cooling. Have them all draw from the same spot, and then all empty back in. That way you get free cooling and it'd be quiet. If you look back at my earlier suggestion involving the water heater, you'd be all set.
Re:It's all about design (Score:4, Insightful)
Personally, I have ONE well-configured machine acting as the firewall, the router, and the file server. There would be a seperate machine providing external 'net service (HTTP) if I could think of any damn good reason I needed a web server at my house.
So, one well-configured machine with 2 NICs, one 8-port ethernet switch and a DSL modem equals: one short Cat5 cable to the DSL modem, 4 power cables (one for the seldom-used monitor), and 8 Cat5 cables run to the rest of the house.
What you and almost everyone else is describing here is more of what you'd find in much more commercial places, and a bit overkill if you ask me. My single-machine setup works just fine, and the advantage of one machine is that you DON'T need any additional cooling.
All of it fits in a closet, and I can work with the server from any part of the house with a tektronix X-terminal, or the computer that happens to be there.
So, I guess I wonder where the advantage is of having enough machines to have to design it so that people get a "feeling" of what my machines' duties are visually? What's the point of having a huge NOC in your house?
Is there a point, or is it just merely to geek-out to the point of overkill, which I can also respect, but can't logically submit myself to?
Re:It's all about design (Score:3, Insightful)
Why on earth is this? Do you hold dinner parties where strangers get to come over and reconfigure your servers? As long as you're bright enough to remember from one day to the next which server is which, who cares how they're arranged? And what is the correct order for a set of servers, anyway? Alphabetical by hostname? Ascending order of system RAM? Uptime? Numerical order of primary service port?
Re:It's all about design (Score:3, Insightful)
Well, if you have three servers, then no, it doesn't really matter.
Suppose you have twenty-three. Now think. You're going to sit down in front of these one day after having spent a month in Bermuda. How will you feel?
I know I'd rather feel the latter.
then there's the geeky-friend situation.
personally, my favourite solution is to label my computers. give them names, and stick the names to them somehow.
Basements DO have drawbacks though. (Score:2, Insightful)
One thing to find out BEFORE you begin mounting expensive electronic equipment down in your nice, cool basement is:
HOW PRONE ARE YOU TO FLOODING?
My parents place was in a well developed subdivision with one decent power drop and one shitty one. Guess which one they were on?
So every time they'd get a bit of rain, BOOM. Out would go the power in their place, and every place down the right-hand side of the block. While our next door neighbors off to the left (and down the left side of the block (we were at the end of a cul-de-sac) had power.
Consequently, if this happened in the middle of the night, they'd take on 3-4 feet of water.
If you're in an area that has no flooding problems, you're set. You can drop your setup down in the basement.
If you live in an area that's flood prone, then take the extra time and money to rig the server room on the main floor.
Have a cold-air return in the floor (or low on the wall) blowing directly into the equipment bay. Then (assuming you're in a one story home), have a ceiling ventilation fan above the rack.
You can find a lot of HVAC supplies to improve your climate control here [smarthome.com]. Look particularly closely at the duct fans.
Re:No, no, no! (Score:2, Insightful)
false flooring (Score:3, Insightful)
In fact, they not only used this technique in their server farms, but also in the production line. When they added on to the line, they dug a 8-foot hole, and then built scaffolding and a false floor. All the plumbing and wiring run under it.
Re:Localized Thermometers (Score:3, Insightful)
Separation of firewall and application duties (Score:4, Insightful)
I personally have two machines - one being nothing but a firewall and router and the other being all those handy services that you need on a home network (file storage, DNS, web proxy, testing DB and web server, etc).
There are good reasons for this split of duties:
In summary - home networks needs 2 machines - one providing security, one providing services.
Re:Natural cooling (geothermal) (Score:3, Insightful)
Insulate the rest of your house (Score:4, Insightful)
Keep (or make) it small! (Score:2, Insightful)
Just as a data point, I have recently consolidated all but one of my servers onto a single little box, drawing a little bit under 100 watts. My UPS can keep this little guy up for two hours during a power outage.
Cold Air Return (Score:2, Insightful)
Usually a "cold air return" is near the floor, as it's intended to remove cold air in the winter. In your server room, have that air return vent connected to openings near the floor and ceiling. Install the type of grill which can be opened and closed, so you can adjust how much air gets pulled from the top and bottom of the room. This lets you keep air circulating, but you now can remove hot air more easily.
Make sure you also run a vent from the furnace to that room, and again have an adjustable grill so you can control how much air enters the room. In the winter you probably want to nearly close it, and allow more of the house air to be drawn through the warm room.
The last thing you need is a Fan Always On switch. Sometimes there is one on the furnace, and sometimes there is one in the thermostat. Leave the fan always on, so you keep air moving and even out the differences.
Last, consider an electronic air filter. This is an electrostatic device installed next to the furnace, in the cold air return. It's a couple of hundred dollars, but it removes well over 90% of stuff floating in the air. If your fan is always running, you also keep running the air through so it is kept nice and clean. You just have to wash the metal filters, no disposable filters to buy. Less dust in the computers.
be prepared (Score:3, Insightful)
Pollution (Score:3, Insightful)
After looking at the server farm in work I figured the first thing to decide is "What the heck is all that stuff going to sound like in my house? It's pretty noisy at work, and the walls are made of breeze block and concrete. I can hear a motor hum through the wall when there's no other noise. In my house, after about 10:30pm there's no noise at all, it's silent. If I leave my desktop PC on overnight you can hear it.
I'd certainly soundproof the walls, and if money was no object, I'd add insulation to keep the heat out. I'd then look at some kind of system to pull dust and fibles out of the air before they reached the equipment. We have an extraction system with filters that are regularly cleaned. Houses get pretty dusty, with the resultant build up all adding to the build up of heat.
I reckon you'd want to sort all that before you started with the actual ecuipment.